Dynamic Sports First Strike T15 Power Tube 2.1 / Upgrade Bolt Sleeve AC

Dynamic Sports Gear T15 Power Tube in the improved 2.1 version!

The Dynamic Sports Gear T15 Power Tube takes the next step with version 2.1. This new version is made to be compatible with all First Strike T15 markers, from generations 2 to 5. It is an upgrade bolt sleeve that was manufactured from a single piece, thus providing some more amenities in addition to increased marker performance.

The DSG T15 Power Tube has a front thread for screwing in barrels. The sleeve is available with either A5 or Cocker threads. This means that almost all standard barrels can now be used with the T15, such as Carmatech Nemesis barrels, Hammerhead barrels, Smart Parts Freak Sets and all other barrels with standard threads. The bayonet lock is omitted.

Another advantage is that barrels are now firmly seated in the receiver. T15 users are often familiar with the problem that the barrel sometimes wobbles a little in the marker housing. Sometimes you had to tighten the cylinder mounting screw on the T15 very hard, and even that did not always help. The new generation 5 model could only provide a small improvement here, but could not completely eliminate the known problem. So the Dynamic Sports Gear Power Tube for the First Strike T15 marker is and remains the only really good solution to this problem.

The high-quality, finely milled aluminum material is designed for maximum durability and has a hard-anodized, cyan blue finish. The blue color was deliberately chosen to make the component clearly recognizable as a trim piece and, unlike the previous gold model, also to be clearly recognizable as version 2.0. Since it is inside the case, you can't see any of the eye-catching appearance from the outside.

Dynamic Sports Gear T15 Power Tube 2.1 can do it

DSG has improved the following points in its 2.1 version of the T15 Power Tube.

1. The valve pin holes were re-aligned to counteract the large design tolerances of the T15 (in the previous model, approximately 10% of the markers had contact points).

2. The thin-walled hole in the recock screw has now been replaced by a triangular milling which is not only more stable, but also ensures that the milled surface now fits 100% precisely in the area of the upper manifold.

3. Instead of a single rear cover guide, the new T15 Power Tube 2.1 now offers 3 guides. Partly as an alternative if a guide breaks off, which unfortunately can happen quickly on the T15 if you open the cover while it is clamped. Also in preparation for the new Dynamic Sports Gear T15 Adjustable Rear Cap with 3 attachment points, which better distributes the forces that arise and thus makes the system more durable. In addition, the new rear cover will have a screw with which the spring tension can be finely adjusted.

4. New color scheme - blue gloss anodized - to clearly identify the product as a 2.1 generation trim part.

Of course, all the features of the previous model have also been adopted one-for-one. So you get the same features as the first model plus the other improvements mentioned above.

The performance upgrade

Tests with the new DSG 2.1 Power Tube have also shown that the marker works more air-efficiently and consistently after installation. Due to the extremely good fit of the accessory, all components in the bolt have significantly less play than in the serial component. This means that the O-rings seal much better and that air is no longer lost in unnecessary holes. In the tests, an additional 2.5 magazines could be fired from a normal 200 bar cylinder with a filling volume of 0.2L. This corresponds to 50 more shots from a single cylinder.

T15 players know about the sensitivity of the cursor to weather. Depending on the outside temperature, the Re-Cock screw in the area of the trigger unit had to be set and adjusted again and again on the standard model. That too has come to an end with the new DSG T15 Power Tube. Not only can you adjust the Re-Cock screw considerably, but the cursor works almost constantly in all weather conditions thanks to the new power tube with a very low basic setting. This is also a reason to save air.

One final feature is the more consistent shot pattern. Due to the improved fit in the bolt O-ring area, the T15 operates more consistently after installation and there are fewer FPS fluctuations. This improves shot pattern and performance.

Specifications about Dynamic Sports Gear T15 Power Tube 2.1:

• Optimized valve pin hole compared to the previous version (solves all issues with version 1.0 and 2.0)
• Revised design of Recock screw milling in triangular design
• 3 guides/contact points for the rear cover, making it significantly more durable
• Prepared for DSG T15 adjustable rear cover (sold separately)
• More consistent shooting speed / FPS
• Re-Cock screw adjustable to almost "zero" in all weather
• Better fit of the internal marker components
• CNC machined from high quality 6061 aluminum material
• Blue hard anodized (surface) for ultra-long life
• The marker is up to 20% more air efficient after installation

Bolts and other internal parts of the marker are not included.